Avoid damage to your machine caused by extended downtime

ELK GROVE VILLAGE, IL, July 10, 2020  

If your die casting machines are not under power for an extended period, You must read the following:

The below recommendations will help keep your machines in good running condition and minimize unplanned downtime:

KEEP YOUR MACHINE LUBRICATED

• If possible, it’s best to actually cast at least one hour a week.  This actuates solenoid valves used in the casting process reducing failures.
• Schedule running of the hydraulic system pumps at least one hour each week while running the plant water cooling system.This will keep the machine temperature more consistent and maintain the corrosion and biocide treatment properties of the cooling water.  This will also allow the hydraulic fluid to circulate preventing  sticky valves. 
• The machine die platen should be opened and closed manually, but with little locking force. 
• The ejector and the injection system should be moved full stroke several times.
• The toggle lubrication system operates only when the pumps are running.  This will supply lubrication to the bushings and linkage pins. 
• Grease all machine fittings as per manual to keep points of motion lubricated

KEEP YOUR MACHINE’S INTERNAL SYSTEMS CLEAN

• The die spray system should be flushed with clean water in order to remove residual die lubricant from the system.
• If possible, use a filter pump cart to clean the fluid during the shutdown. 
• Inspect and service the injection position sensor.  Hydraulic fluid may have leaked on the sensor causing it to stick.
• Change machine hydraulic filters

KEEP YOUR MACHINE’S SYSTEMS MEMORY OPERATIONAL

• This is also a good time to replace the backup batteries for the PLC and auxiliary equipment.

We want to be your service and support partner!

If you have any questions, or require additional assistance, please contact our service department at:

dc-svc@Shibaura-Machine.com

Shibaura Machine Company, America

Die Casting Team